Natural oil gives your floor lasting protection, a trendy matte finish and brings out the grain of the wood. A few simple habits are all it takes to keep your floor looking beautiful.
Drying and curing
After the oil is applied, under normal conditions:
- Normal foot traffic after 24 hours.
- Wait 24 to 36 hours before putting furniture back.
- Only if necessary: walk in dry cotton socks after at least 12 hours, if the surface is not sticky. Always make sure the surface is not sticky.
High humidity, cold air or a dark stain can extend these times, sometimes by several days.
The oil fully cures in about 15 days. During that time, don’t cover the floor for long periods, keep the room well ventilated, avoid dragging or sliding objects, and lift your furniture rather than pushing it.
After 15 days, you can put down rugs and mats. Avoid rubber rug pads and rubber furniture feet, which can soften or discolour the oil: use felt pads instead.
Cleaning and maintenance
- Wait about 30 days before the first wash.
- Regular care: a soft broom or vacuum, then a cotton mop with a very well wrung-out cloth and lukewarm water.
- The cloth should be almost dry. If you see water on the floor, there is too much: excess moisture can damage the wood.
- In most cases, water alone is enough, applied with a well wrung-out damp cloth. Never use large amounts of water.
- pH-neutral cleaners (pH 7 is the pH of water) are generally unnecessary for frequent use and can leave residue.
- A well wrung-out damp cloth remains the best method. Traditional microfibre mops are not recommended, because the texture of the wood catches the fibres.
- Some water-only floor cleaners with a microfibre roller give excellent results in our experience, but they are not necessary.
- Wipe up any spills quickly.
Soap Oil (optional)
Vermeister Soap Oil is not a cleaner. It is applied after cleaning, on a clean, dry floor, to nourish and refresh the wood and keep dirt from becoming ingrained. It never replaces cleaning and is never used undiluted. Too much product, or a dirty floor, causes residue to build up, which dulls and clogs the finish.
- First clean with a well wrung-out damp cloth, then let the floor dry completely.
- About 5 sprays per 100 sq. ft., spread with a cotton mop and a clean, slightly damp, lint-free cloth. Do not rinse.
- Let dry 30 to 60 minutes without walking on it, even in socks.
- Occasional use: generally every 6 months, or depending on wear.
Restoring the original matte finish: over time, a floor can become glossier, because of patina or another oil that was applied to it. Soap Oil is then the product to use to gradually bring it back to the matte finish we gave it. It generally takes several applications; how many depends on each situation. If in doubt, contact us.
Oxidation and colour variation
Oil changes with time and light. An area that was covered and then exposed may have a different shade from the rest of the floor. This is a natural phenomenon, not a defect in the material or the workmanship, and it tends to fade over time.
Protecting your floor
A stiletto heel, or a heel whose tip is worn, concentrates all the weight on a very small area. Furniture without felt pads, heavy objects being dragged, sand, pebbles and pet claws can also mark the wood.
- Put felt pads under furniture and check them regularly.
- Lift furniture instead of dragging it.
- Place a mat at the entrance.
- Trim your pets’ claws regularly.
- Avoid worn heels on the floor.
This kind of damage is not a defect in the floor or the workmanship.
Humidity in your home
Keep the humidity in your home stable, around 45%, all year round. Wood is a natural material: in winter, heating dries the air, the wood shrinks and small gaps can appear between the boards. A humidifier helps maintain an acceptable level. These gaps usually close up again in summer.
Good to know
Most problems are caused by improper maintenance. If in doubt, contact us before using any product. Following this guide is a condition of our lifetime sanding guarantee. Questions? Call us at 514-984-1160.

